User's Manual

Camera Installation

Before you install the camera, carefully plan where and how it will be positioned, and where you will

route the cable that connects the camera to the power adaptor.

Before starting permanent installation, verify its performance by observing the image on the receiver

when camera is positioned in the same location/position where it will be permanently installed and the

receiver is placed in the location where it will be used most of the time.

Installation Warnings

Aim the camera(s) to best optimize the viewing area: Select a location for the camera that provides a

clear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong

light source or direct sunlight.

Avoid installing the cameras where there are thick walls, or obstructions between the Cameras and the

Receiver.

Night Vision

This camera has built-in IR LEDs , which provides the camera with the ability to view images in no/low

light conditions.

Installing the Camera

1. Carefully unpack the camera.

NOTE: If you are installing cameras that did

not come with the system, please see the

pairing camera section of this manual for

details on installation.

2. Mount the camera to the wall.

Mark the position of the screw holes on the

wall, and drill holes and insert 3 screws, then

firmly attach the camera to the wall. Make

sure to strongly secure the screw the mounting bracket into the wall

NOTE: The camera can also be placed on a flat surface, such as a Table or Shelf, and no mounting

hardware is required.

3. Adjust the viewing angle of the camera. You can adjust camera angle to desired viewing area.

NOTE: You can install additional cameras (maximum of 4 cameras). When adding cameras that were not included

in the original box, you will need to pair up the cameras with the receiver. Refer to the camera pairing section of

this manual.

Connecting Camera Power

The camera can be powered by using the provided power adaptor