Guardian UDRC58 Accessory Camera UDRC58HD
Wireless Camera 1.Microphone –Captures the sound on camera side and transmits the sound from camera to receiver. 2.Night vision lights –24 pcs Night vision lights 3. Camera Lens –Catches the video in front of the lens and transmits video from camera to receiver. 4. IR LEDs – Infrared LEDs provide viewing in no/low light conditions 5. PIR Sensor – Detects motion in front of the lens and emits detection signal to transmitter. 6. Speaker – Produces the sound transmitted from the receiver. 7.
Camera Installation Before you install the camera, carefully plan where and how it will be positioned, and where you will route the cable that connects the camera to the power adaptor. Before starting permanent installation, verify its performance by observing the image on the receiver when camera is positioned in the same location/position where it will be permanently installed and the receiver is placed in the location where it will be used most of the time.
Power Adaptor Connect the power adaptor to the camera. Make sure is the DC 9V for camera, and DC 5V for Receiver Make sure the power adaptor is placed into a grounded outlet or surge bar to protect the camera from power fluctuations. Set Up Cameras And Monitor 1 Attach power adapters to the cameras. Plug into power using 9V,2A adaptor 2 Attach power adapter to the monitor. Plug into power using 5V,2A adaptor 3 Turn on monitor. You should see General Settings, tap and come into Camera setup.
Main Screen Sub-Screen What it Does Paring This system comes with cameras already paired. Use Pairing to assign these cameras to different channels or to pair additional new cameras to the monitor. ON/OFF Makes the cameras visible to the monitor. Resolution Adjusts the video quality of each camera. Camera Setup Pairing Your cameras are paired to the monitor at the factory to channels 1 and 2.
Electrical Parameter: Camera(s) Transmit Frequency Range 2408Mhz~2468Mhz Data Rate 6 Mbps Transmitting Distance 150m Image Sensor Type PO2210N 1/2.7”FHD Cmos Image Sensor Effective Pixels H: 1920 Light sensitivity 3.5 Lux (w/o IR-LEDs) Image Processing H.264 (Line of Sight) V: 1080 Cam x 2 : 1080Px1 @ 10 fps Image Resolution / Frame Rate Cam x 2 : 720Px2 @ 25 fps Cam x 4 : 720Px 4 @ 15 fps Lens 3.6mm / F1.
IC Caution: IC Note : Cet appareil est conforme à la Partie 15 des règlements de la FCC et aux normes RSS de l’Industrie du Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer des interférences nuisibles, et (2) cet appareil doit accepter toute interférence reçue, y compris les interférences qui peuvent provoquer un fonctionnement indésirable.
