User's Manual
3
1. Connect one end of the
cable to the back of the receiver, the another end
(RCA cord) to your television's A/V inputs, the yellow plug to the VIDEO IN
jack and the white plug to the AUDIO IN jack.
2. Plug the receiver power adapter into the
9V DC power jack on the back of
the receiver and plug the power adapter into any
120 V/240
V power outlet.
3
. Place the receiver either on top or near to your TV. Rotate the antenna to a
vertical position.
OPTIMIZING THE WIRELESS CAMERA SYSTEM
The
900MHz video signals pass easily through your home’s interior walls, but
the signal may be reflected
by power wires or plumbing inside the wall. Usually
a slight adjustment of the Receiver and/or Camera
antenna will improve
reception. Take care not to force the antennas past their lock positions.
MULTI
-CAMERA OPERATION
Our w
ireless 900MHz Camera system is designed to work with up to 2
Camer
as. Additional Cameras are sold separately.
IMPORTANT: When using more than one Camera,
please check channel
number on package,
make sure it is exclusive to each camera.
Accordingly
the
dip switch located on the back of the Receiver should be adjusted to reflect
the channels in use.
OPERATING THE SYSTEM
Set your TV to monitor the VIDEO INPUT designated for the Receiver.
The receiver can
support up to two different camera/transmitter signals. You
can switch from one camera
to the next either manually or automatically via
button on
the top panel of the receiver.
MANUAL
MODE
To select one of the
two channels manually, press the MANUAL button on the
panel of the receiver.
T
he receiver will switch to a different channel (CAM1, CAM2) each time when
the MANUAL
button is pressed. To avoid searching channels that do not have
4
cameras/transmitters
assigned to them, set the DIP switches (located on the
rear
panel of the receiver) for those corresponding channels to the OFF
position
(up). When you have selected a channel with an active camera, that
video will
appear on your TV screen.
AUTO
MODE
To have the receiver automatically rotate
through the channels, press the
AUTO button on the
top panel of the receiver. The receiver will continuously
scan through all chan
nels which are ON. To avoid searching channels that do
not have cameras/transmitters assigned to them, set the
DIP switches for those
corresponding channels
to the OFF position. The monitor will display the
picture
from one camera to the next. The dwell time (time taken to switch
between cameras) is preset to 4 seconds and can be adjusted
between 2-30
seconds. To adjust the dwell time, press both the AUTO and MANUAL button
simultaneously.
Each flash of the LED increases the dwell time by one second.
TROUBLE SHOOTING
If you are having trouble operating this product, please consult the guide
below:
SYMPTOM REMEDIES
No camera picture
1. Check all connectors. Make sure camera(s) and
receiver are switched ON.
2. Ensure camera(s) and receiver are set to correct
channel(s).
3. Make sure camera is within range of receiver.
Blank monitor
1. Make sure receiver is switched ON.
2. If using AC adapter, make sure it is plugged in.