User's Manual

5
Interference on
camera picture
1. Make sure each camera (transmitter) is within
range, and that no large obstructions are blocking the
signal.
2. Try repositioning the camera, receiver or both to
improve the reception quality.
3. If a camera is positioned close to the receiver, point
antenna away from the receiver.
Audio problems
1. Ensure the volume is turned up sufficiently on the
TV.
2. Make sure the sound is within the microphone
range.
3. If the unit emits a loud wailing sound (feeds back),
try moving the camera away from the receiver or
angle the receiver differently.
SPECIFICATIONS
Camera
TV System
PAL or NTSC
Resolution
360 horizontal TV Lines
Signal/Noise Ratio
48dB
High
-Speed Electronic Shutter 1/60 - 1/15,000 sec
Image Sensor
1/3” CMOS
Min. Illumination
0.1 lux
Current Consumption
150mA
Overall Size
2.36"L×1.69" Diameter
Frequency
910MHz, 920MHz
Modulation
FM
Video Signal/Noise Ratio
48dB
Audio Signal/Noise Ratio
45dB
Case Finish
Metal Aluminum case, suited for indoor or
outdoor use
2
monitored
• The Camera should
be aimed accordingly to optimize viewing area
• For best transmission, avoid installations where there are thick walls or major
obstructions between the Camera and Receiver
INSTALLING THE CAMERA (TRANSMITTER)
1. Unpack the Camera.
2
. Decide whether the Camera will be wall-mounted or sit on a desk/table top. If
wall mounting, use
the hardware kit in the package. The Camera can be
adjusted for either mounting
scenario by rotating the Camera to the required
position.
DESK TOP WALL MOUNTING
3
. If using the 9V camera power adapter, just connect power jack. Make sure
the Camera is
positioned no more than 5 1/2 feet from an AC power outlet.
4. Each
camera’s channel number can be set by user, screw the lens part of
came
ra to open the lens cover, and then could set the camera’s channel
number. After finish setting the channel, screw the lens cover on.
5.
The Camera (Transmitter) installation is now complete.
Night
Vision///
The Camera includes IR LEDs, which allows viewi
ng up to 12 feet in the dark
when
used with the adapter. It can automatically turn to night vision in low light.
SETTING UP THE RECEIVER