User's Manual

LI-polymer special battery to the camera. If using the 9V camera power adapter, just
connect power jack. Make sure the Camera is positioned no more than 5 1/2 feet from an
AC power outlet.
4. Select the Camera operating channel under the housing of the camera by moving the
slide switch to position 1 or 2. Switch is preset to channel 1
.
The Camera (Transmitter) installation is now complete.
SETTING UP THE RECEIVER
1. Connect one end of the cable (
RCA <male>) to the rear of the receiver, another end
(RCA cord) to your television's A/V inputs, the yellow plug to the VIDEO IN jack and the
white plug to the AUDIO IN jack.
2. Plug the receiver power adapter into the 9V DC power jack on the back of the receiver
and plug the power adapter into any 120 V/240 V power outlet.
3. Place the receiver either on top or near to your TV. Rotate the antenna to a vertical
position.
OPTIMIZING THE WIRELESS CAMERA SYSTEM
The 900MHz video signals pass easily through your home’s interior walls, but the signal
may be reflected by power wires or plumbing inside the wall. Usually a slight adjustment of
the Receiver and/or Camera antenna will improve reception. Take care not to force the
antennas past their lock positions.
The most common source of interference is microwave ovens and cell phones. Try to
avoid mounting the Receiver near a microwave oven or other source of RF interference
such as cordless phones.
MULTI-CAMERA OPERATION
This 900MHz wireless surveillance system is designed to work with up to 2 Cameras.
Additional Cameras (With different shapes for your option) are sold separately.
IMPORTANT: When using more than one Camera, make sure each camera is
assigned to a specific channel by adjusting the corresponding slide switch position.
Accordingly the slide switch located on the rear of the Receiver should be adjusted to
reflect the channels in use.
OPERATING THE SYSTEM
Set your TV to monitor the VIDEO INPUT designated for the Receiver.
The receiver can support up to two different camera/transmitter signals. You can switch
from one camera to the next either manually or automatically via button on the top panel of
the receiver.
MANUAL MODE
To select one of the two channels manually, press the MANUAL button on the top panel of
the receiver.
The red LED will light and the receiver will switch to a different channel (CAM1, CAM2)
each time when the MANUAL button is pressed. To avoid searching channels that do not