User's Manual

2. Decide whether the camera will be wall mounted or sit on a tabletop. If on a tabletop, install it as it

is. If wall mounted, loosen the screw on the bracket and pull the camera out of the base bracket.

Then insert the camera to the other hole in the base bracket (as shown in above pictures), then tight

the screw. Use the hardware kit in the package and drill template to mount the base bracket onto the

wall. The camera can be adjusted by rotating the camera to required position.

3. Plug the power adapter for the camera to a power outlet and connect the other end to the camera.

4. Each camera’s channel can be set by users. Move the slide switch to position 1 or 2 to set the

camera channel

The camera installation is completed.

Night Vision///

The camera includes 8 IR LEDs, which allows viewing more than 20 feet in the dark when used with

the power adapter. It can automatically turn to night vision mode in low light.

SETTING UP THE RECEIVER

1. Connect the A/V cable to the back of the receiver, the other end (RCA cord) to the A/V inputs of a

TV or other viewing and recording devices, the yellow plug to the ‘VIDEO IN’ jack and the white

plug to the ‘AUDIO IN’ jack.

2. Plug the power adapter for the receiver to a power outlet and connect the other end to the

receiver.

3. Rotate the antenna to vertical position.

The receiver installation is completed.

OPTIMIZING THE WIRELESS CAMERA SYSTEM

The 900MHz video signals can pass easily through your home’s interior walls. And usually a slight

adjustment of the receiver antenna can improve the signal reception. Take care not to force the

antenna past their lock positions.

TWO CAMERAS OPERATION

This 900MHz Wireless Color Camera System can support 2 cameras. Additional camera is sold

separately. When using 2 cameras, please set the 2 cameras to different channels, accordingly the

two dip switches located on the back of the receiver should be both switched on.