User's Manual

4
7. Wall Mounting Hole – Screw the wall mounting bracket to the hole, then fix the bracket to the wall to
mount the receiver on the wall.
8. Zoom Button – In “×1” mode, press to enter “×2” mode, ×2 shows on the screen; In “×2” mode,
press to enter “×1” mode, ×2 doesn’t show on the screen.
9. Joystick – A. Navigation button (▲▼◄► arrows): servicing button, can control direction of Pan/Tilt
cameras. B. Enter/Del button: servicing button, used for upgrading software; when enter File list, pick a
recorded file and press Del to delete the video. Before the file is completely deleted, you can see a
warning Del xx? You can choose to delete the file or keep it.
10. A/V – Press it to enter A/V Out mode and press again to back to Lcd mode; if the Lcd is powered off
in A/V Out mode, it stays A/V Out mode when power on again.
11. Power Switch– Slide the switch to ON or OFF position to switch on/off the receiver.
12. Microphone– Receives sounds from the area near the receiver and transmits sound from the
receiver to the camera (only when TALK is pressed down and held)
13. DC 5V Power Input – Connect the included DC 5V power adaptor to power the receiver.
14. SD Card Slot – Insert SD card to this SD card slot for both video and4 audio recording.
15.
USB Port: Used webcam function5 (Skype, MSN) and for firmware upgrade
16.A/V Out Port – Connect the included A/V cable to view video from the receiver on a TV or monitor, or
record to a VCR/DVR.
17. Receiver Stand – Enables the receiver to stand on a flat surface, such as a table or countertop. You
can also adjust the viewing angle by rotating the stand.
Wireless Receiver Installation
The LCD Receiver can be setup for use on a tabletop, or mounted to a wall or underneath
a counter or cupboard.
1. Before receiver installation, choose one installation method from below 3 methods:
1). Desktop or table stand.
For this method, you only need to place the receiver on a desktop and use the supplied receiver stand.
2). Hung on the screw which is fixed on a wall.
Decide where to hang the receiver first. Make sure the range between the position and the nearest
power output port is no more than 5 feet.
Drill a hole on the wall where you decide to hang the receiver, insert one plastic anchor and fix a screw
into the plastic anchor. Now the receiver can be hung on the screw (receiver back control number ⑤).
3). Wall mounting
Decide where to install the receiver first. Make sure the range between the position and the nearest
power output port is no more than 5 feet.
Screw supplied wall mounting bracket to the receiver (receiver back control number ⑥), then drill 3
holes on the wall where you decide to install the receiver, then insert 3 plastic anchors and fix the wall
mounting bracket to the anchors with supplied screws.