User's Manual
Wireless Camera
1. Camera Antenna
–Receives
&
Sends signals to
or
from
the
Receiver.
2. Lens – Catches the video in front of the lens and transmits video
from camera to receiver.
3. IR LED
–Infrared
LEDs
provide
viewing
in
no/low
light
conditions.
4. PIR sensor
–
Detects motion in front of the lens and emits
detection signal to transmitter.
5. Thumbscrew
-Rotates the thumbscrew to adjust the angle of the
camera until the desired view is set
6. Speaker-
Produces the sound transmitted from the monitor.
7.
Bracket
–
Use the bracket to mount the camera on a wall or other
flat surfaces.
8.
Pairing Button
–The
pairing
button
is
located
on
the back
of
the
camera
behind by
the
stand mount.
9. Power Jack
–Connect
the
DC
5V
Power Adaptor to
the
Camera.
Note: This camera includes an Auto Mechanical IR Cut Filter. When
the camera changes between day mode and night vision mode, an
audible clicking noise may be heard coming from the camera. This
clicking is normal, and indicates that the camera filter is working.
Camera Installation
Before
you
install
the
camera,
carefully
plan
where
and
how
it
will
be
positioned,
and
where
you
will
route
the
cable
that
connects
the
camera
to
the
power
adaptor.
Before
starting
permanent
installation,
verify
its
performance
by
observing
the
image
on
the receiver
when
camera
is
positioned
in
the
same
location/position
where
it
will
be
permanently installed
and
the
receiver
is
placed
in
the
location
where
it
will
be
used
most
of
the
time
Installation Warnings:
Aim
the
Camera(s)
to
best
optimize
the
viewing
area:
Select
a
location
for
the
camera
that provides
a
clear
view
of
the
area
you
want
to
monitor,
which
is
free
from
dust,
and
is
not
in
line-of-sight
to
a
strong
light
source
or
direct
sunlight.
Avoid
installing
the
cameras
where
there
are
thick
walls,
or
obstructions
between
the
Cameras and
the
Receiver.