User's Manual

Wireless Receiver Installation
1. Before receiver installation, choose one installation method from below 2 methods:
1). Desktop or table stand.
For this method, you only need to place the receiver on a desktop.
2). Wall mounting
Decide where to mount the receiver first. Make sure the range between the position and the nearest
power output port is no more than 5 feet. Also, the range between the position and TV or VCR/DVR
should be no more than 5 feet.
Drill two holes on the wall where you decide to install the receiver. Insert a plastic anchor to each hole
and fix a screw into the plastic anchor. Insert the screws into the two holes located on the bottom of
receiver and then push down the receiver.
Adjust the receiver for best viewing angle.
2. After the receiver is well positioned, plug the AC adaptor power output cable into the 5V POWER input
of the receiver, and plug the power plug into a wall outlet or surge protector.
3. If you wish to view the receiver images on a larger screen, connect one end of the included AV cable
to the AV output of receiver, and connect the other end to the Video IN (Yellow) and Audio IN (White)
ports on the TV, VCR or other viewing/recording devices.
Note: When outputting Audio/Video to TV, etc, press the AV button on the remote control to output audio
and video to TV.
The receiver installation is now completed.