User's Manual

NOTE: It is highly recommended to pair the cameras to the receiver before permanently mounting the
cameras.
The pairing function assigns each camera to a different channel on the wireless receiver (up to 4
cameras), and is necessary for configuring additional cameras.
NOTE: It is highly recommended to pair the cameras to the receiver before permanently mounting the
cameras.
1. Power on the receiver by connecting it to power outlet with supplied 5V power adaptor.
2. Power on the camera by connecting it to power outlet with
supplied 9V power adaptor.
3. Press the Menu on the receiver. Navigate to the Pairing menu
option by pressing the joystick up/right arrow to select the
desired pairing channel. Press OK to enter the pairing operation.
4. Select a channel and press OK to confirm the selection.
5. A message will be displayed on the receiver screen.
The receiver will count down from 30~0 – you must press the
Pair button on the camera during this time to successfully pair
the camera.If the button on the camera is not pressed, the
receiver will return to the view screen, and no pairing will take
place.
6. Following the on-screen prompt, press the Pair button on the
back of the camera. You have 30 seconds to press the Pair
button on the camera, once paired, after 3s will see the live video
on monitor .
-Camera On/Off :
Select a camera by pressing
, then pressing /
to switch on or switch off the camera. Press
to
confirm the change and exit.
NOTE: The currently selected camera will have On/Off
highlighted in Green. Any disabled channels will be
blacked out in Quad mode when you pair 4 cameras.