User's Manual

6
Remote Control
The remote control is supplied to operate the receiver. It includes all the operations on the receiver
except talking back to camera.
Note: When using remote control, it is recommended to have it point at the IR reception port which is
above the LCD screen.
Quad – Press Quad button to view the images in quad mode.
Press (Channel) A, (Channel) M or Quad button again to exit
from quad mode.
Menu –Press to access the receiver menu. Press the button again
to exit.
Enter – In viewing mode, press to enter playback interface for
recorded videos.
Navigation/Enter – Use the buttons to control the receiver in
Quad Mode, Menu Mode and Playback mode.
- Quad Mode: In quad mode, press a navigation button to view
the image from the corresponding camera in full screen mode.
- Menu Mode: Use the navigation buttons to navigate in Menu
Mode. Press the Enter button to confirm the menu selection.
- Playback Mode: In playback mode, use the navigation buttons
to play/pause, stop, forward, backward.
Scan/Del – In viewing mode, press the button to switch the
receiver to scan mode. In scan mode the LCD screen is turned off
or displays a static picture, and the system continuously scans all available cameras. The indication LED
SCAN below the LCD screen will be on.
If motion is detected by the camera(s), the receiver will beep and display the image from the triggered
camera. The receiver will return to scan mode about 5 seconds after the alarm has completed. Press
Scan, (Channel) A or (Channel) M buttons will cancel scan mode.
In playback interface, press the button to delete recorded files from SD card.
(Record) Motion – Press the button to switch the system to automatic recording mode. In this mode, the
indication LED AUTO REC will be on and the receiver starts recording when motion detected by a
camera. The recording time can be set to 15s or 30s.
(Record) ● – Press the button to start recording, press it again to stop recording.
(Channel) A – Press the button to view cameras in automatic switching mode.
(Channel) M – Press the button to manually switch between all activated cameras.
AV – When connecting the receiver to TV or VCR/DVR, press the button to output audio/video. When
outputting audio and video, the LCD screen will be switched to blank.
Vol- / Vol+: Press the buttons to adjust the volume.