User's Manual

Wireless Camera

Front & Side Controls

1. Camera Antenna – Sends & receives

signals to or from the receiver.

2. AC Adaptor Jack – Plug the AC

adaptor to the jack for camera’s power

supply.

3. Wall Mounting Bracket – Use the

bracket to mount the camera on a wall or

other flat surfaces.

4. IR LEDs – Infrared LEDs provide

viewing in no/low light conditions

5. Lens – Catches the video in front of

the lens and transmits video from

camera to receiver.

6. PIR Sensor – Detects motion in front

of the lens and emits detection signal to

transmitter.

Bottom Controls

7. Microphone – Receives sounds from

the area near the camera, and transmits

sound from the camera to the receiver.

8. Speaker – Produces the sound

transmitted from the receiver.

Back Controls

9. Pair Button – The pair button is

located on the back of the camera, it is

used to pair the camera with receiver.

Camera Installation

Before you install the camera, carefully plan where and how it will be positioned, and where you will

route the cable that connects the camera to the power adaptor.

Before starting permanent installation, verify its performance by observing the image on the receiver

when camera is positioned in the same location/position where it will be permanently installed and the

receiver is placed in the location where it will be used most of the time.