User's Manual

3
9. TALK Button – Press down and hold this button to talk back to the camera which’s image is displayed
on the screen.
10. Microphone – Receives sounds from the area near the receiver and transmits sound from the
receiver to the camera (only when TALK Button is pressed down and held).
11. Power Slide Switch – Slide the switch to ON or OFF position to switch on/off the receiver.
12. DC 5V Power Input – Connect the included DC 5V power adaptor to power the receiver.
13. SD Card Slot – Insert SD card to this SD card slot for both video and audio recording.
14. A/V Out Port – Connect the included A/V cable to view video from the receiver on a TV or monitor, or
record to a VCR/DVR.
15. Receiver Stand – Enables the receiver to stand on a flat surface, such as a table or countertop. You
can also adjust the viewing angle by rotating the stand.
Wireless Receiver Installation
1. Before receiver installation, choose one installation method from below 3 methods:
1). Desktop or table stand.
For this method, you only need to place the receiver on a desktop and use the supplied receiver stand.
2). Hung on the screw which is fixed on a wall.
Decide where to hang the receiver first. Make sure the range between the position and the nearest
power output port is no more than 5 feet.
Drill a hole on the wall where you decide to hang the receiver, insert one plastic anchor and fix a screw
into the plastic anchor. Now the receiver can be hung on the screw (receiver back control number ⑤).
3). Wall mounting
Decide where to install the receiver first. Make sure the range between the position and the nearest
power output port is no more than 5 feet.
Screw supplied wall mounting bracket to the receiver (receiver back control number ⑥), then drill 3
holes on the wall where you decide to install the receiver, then insert 3 plastic anchors and fix the wall
mounting bracket to the anchors with supplied screws.
2. After the receiver is well positioned, plug the AC adaptor power output cable into the 5V POWER input
of the receiver, and plug the power plug into a wall outlet or surge protector.
3. If you wish to view the receiver images on a larger screen, connect one end of the included AV cable
to the AV output of receiver, and connect the other end to the Video IN (Yellow) and Audio IN (White)
ports on the TV, VCR or other viewing/recording devices.
Note: When outputting Audio/Video to TV, etc, press the AV button on the remote control to output audio
and video to TV.
The receiver installation is now completed.