User's Manual

9
Accessing Menu System
The functions of the Menu button and navigation buttons/Enter button on the remote control are the
same as the joystick and Menu button on the back of receiver. In this section we take the remote control
as example to show the menu operation.
Press the Menu button on the remote control to enter menu system. Use the navigating buttons to
navigate up/down/left/right in the menu, and press the Enter button to confirm a setting or selection.
Main Menu
The Main Menu contains 4 submenus:
1. Camera On/Off – Use the menu to switch on or switch off a
specified camera.
2. Record – Use the menu for SD card recording settings.
3. Pairing – Use the menu to add camera(s) to the receiver.
4. Setting – Use the menu for system settings, such as alarm
volume, brightness and date & time setting.
Camera On/Off Menu
Select a camera by pressing the UP ▲or DOWN ▼ button, then
pressing LEFT
or RIGHT button to switch on or switch off
the camera. Press Enter button to confirm the change and exit.
Record Menu
You can set up the recording parameters in record menu.
Note: To use the recording function, make sure a SD card is
inserted into the SD card slot. When there is new video recorded,
the indication LED NEW below the LCD screen will be on, and
when the SD card is full of memory, the indication LED FULL will
be on.
- Quality: The resolution of recorded videos. There are two
options: 320 x 240 pixels and 640 x 480 pixels.
Record videos are much clearer in 640 x 480 pixels mode but
more fluent in 320 x 240 pixels mode.
- Trigger Record: The recording time when there is motion
detected by a camera in automatic recording mode. The
recording time can be set to 5s, 15s or 30s.