User's Manual

2
Wireless Receiver
1. Receiver Antenna – receives signals from the camera(s). Adjust the antenna to vertical position for
better signal reception.
2. DC 9V Power Input – Connect the
included DC 9V power adaptor to power
the receiver.
3. A/V Out Port – Connect the included
A/V cable to view video on a TV or
monitor, or record to a VCR/DVR.
4. Alarm Volume Knob – Turn the knob
to increase or decrease the volume of
the audio alarm.
5. Indication LEDs – Indicates the
status of the system. There are 6
indication LEDs:
MANUAL: Indicates manual switching
mode between activated cameras.
AUTO: Indicates automatic switching
mode between activated cameras.
M: Indicates manual recording mode.
A: Indicates auto recording mode. In this
mode receiver starts to record when there is motion detection in camera side.
NEW: Indicates new recorded video.
FULL: Indicates that the SD card is full of memory. It is only available when Overwrite is disabled.
6. Operation Buttons – Use these buttons for receiver operation.
(Channel) M – Press the button to manually switch between all activated cameras. Once the button is
pressed, the indication LED MANUAL will be on.
(Channel) A – Press the button to view cameras in automatic switching mode. Once the button is
pressed, the indication LED AUTO will be on.
(Record) M – Press the button to start recording, press it again to stop recording. In this manual
recording mode, the indication LED M will be on.
(Record) A – Press the button to switch the system to automatic recording mode. In auto recording
mode, the indication LED A will be on and the receiver starts recording when motion detected by a
camera. The recording time can be set to 15s or 30s. Press the button again to cancel automatic
recording.
Quad – Press Quad button to view the images in quad mode. Press Quad or (Channel) A buttons to
exit from quad mode to automatic switching mode, press (Channel) M button to exit from quad to
manual switching mode.