User's Manual

Accessing Menu System

The functions of the Menu button and navigation buttons/Enter button on the remote control are the

same as the navigation buttons/OK button on the upper side of receiver. In this section we take the

remote control as example to show the menu operation.

Press the Menu button on the remote control to enter menu system. Use the navigating buttons to

navigate up/down/left/right in the menu, and press the Enter button to confirm a setting or selection.

Main Menu

The Main Menu contains 4 submenus:

1. Camera On/Off – Use the menu to switch on or switch off a

specified camera.

2. Record – Use the menu for SD card recording settings.

3. Pairing – Use the menu to add camera(s) to the receiver.

4. Setting – Use the menu for system settings, such as alarm

volume, brightness and date & time setting.

Camera On/Off Menu

Select a camera by pressing the UP ▲or DOWN ▼ button, then

pressing LEFT

or RIGHT button to switch on or switch off

the camera. Press Enter button to confirm the change and exit.

Record Menu

You can set up the recording parameters in record menu.

Note: To use the recording function, make sure a SD card is

inserted into the SD card slot. When there is new video recorded,

the indication LED NEW will be on, and when the SD card is full

of memory, the indication LED FULL will be on.

- Quality: The resolution of recorded videos. There are two

options: 320 x 240 pixels and 640 x 480 pixels.

Record videos are much clearer in 640 x 480 pixels mode but

more fluent in 320 x 240 pixels mode.

- Trigger Record: The recording time when there is motion

detected by a camera in automatic recording mode. The

recording time can be set to 5s, 15s or 30s.