User's Manual

EV: This menu is to adjust the exposal value. There are 6 grades from the lowest to highest exposal
value.
Power Saving: This is for the adjustment of automatic power saving time when there is no operation in
the monitor. Users can choose 1 minute, 2, 5 or 10 minutes. Press ‘Cancel’ to cancel the operation.
Setting: This is for the settings of the monitor.
·A/V Out \ Resolution: There are two options for the A/V output resolution of the monitor: Low and High.
In Low Resolution, the image plays better but the picture is not clear enough, while in High Resolution,
the picture in much clearer but the image is not fluent enough.
·Default: Select this menu to restore the monitor to ex-factory settings.
NSTRUCTIONS TO THE USER:
The user is cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user’s authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interferences will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
III