User's Manual

Wireless Receiver Installation

1. Place the receiver in a place that will have clear reception with your camera(s).

2. Plug the AC adaptor power output cable into the 5V POWER input of the cradle or receiver. Plug the

power plug into a wall outlet or surge protector.

3. Leave the receiver to charge for several hours prior to first time use so the built-in rechargeable

receiver battery is fully charged. DO NOT remove the power cable from the receiver / from the cradle

during initial charge process. After initial charge, charge the receiver as required.

Wireless Camera

1. Temperature sensor- Measure the temperature

2 Camera Antenna – Sends & receives signals to or from the

receiver.

3 DC 5V Power – Connect the DC 5V power adaptor to the camera

4 Light sensor- measures light intensity on the camera side

5 Infrared leds – Infrared LEDs provide viewing in no/low light

conditions

6 Lens- camera lens

7 Microphone – Receives sounds for the area near the camera, and

transmits sound from the camera to the receiver.

8 power On/Off - Slide the switch to ON or OFF position to switch

on/off the camera.

9 Volume Control- Silde the switch to increase or decrease the

sound volume

10 Pair Button – The pair button is located on the back of the

camera behind the stand mount.

11 Ceiling mounting switch- For ceiling mounting, use the ceiling

mounting switch to invert the video image