User's Manual

Wireless Receiver

1. SCAN Button – When the SCAN button is

pressed, the screen is turned off. Durning this time

the parent unit will continuously scan the camera

( or multiple cameras). When a sound is detected,

the parent unit will become active. The screen is

turned back, now you can see what happen in the

baby room. You can adjust the sound sensitivity

for this detection in VOX. After the monitor has

detected sound it will take about 5 seconds to

switch back to the scan mode. Except when the sound is continuously detected. In that case the monitor

will be activated for another 5 seconds. There are 2 reasons to use the scan button:1- to prevent you

from being disturbed by bright LCD screen, or 2- save energy. Press the scan button to deactivate the

scan mode.

2.Video ON/OFF Button— Press the video button to switch to the sound only mode. In this mode the

screen is turned off. Press the button again to return from the sound only mode to the sound and video

mode

3. Volome down(-) —Press (-) to decrease the volume

4 Volume up(+)— Press(+) to increase the volume

5 Talk button — Press this button to speak through the baby unit. The icon

will then be display on

screen. When multiple cameras are used, you will speak through the unit currently being display on the

screen.

Front Touch Button Control

6. Sound bar-. The green/red LEDs indicate the

volume level (from low to high)

7. Power Led- The green LED indicates the

receiver power is ON or OFF

8. Play/Stop-Press this button to start or stop the

baby unit playing a lullaby

9. Next button- Play the next lullaby. There are

three different lullabies available

10 Manual Recording- press this button to

recording,

is displayed at the top of the

screen. Press this button again to return the normal mode.

11.Cam button-1) press this button to change from one camera to another,