Owner's Manual

25
Cubes are partially
formed or are white
on the bottom.
Not enough water in the
water trough.
Check if the water supply pressure is below
15 psig.
Check water supply or filter may be
restricted.
Check for a water leak at the water trough.
Noise during
operation
The feet are not leveled and
locked.
Level and lock the feet. See Leveling the Ice
Maker.
Certain sounds are normal.
See Normal Sounds.
The ice maker stops
suddenly while
making ice.
The electricity is off.
Reconnect the power supply line.
The environment
temperature is out of the
stated range.
Cut off the electricity and leave the ice
maker disconnected until the temperature
returns to within the stated range.
The ice storage bin is full of
ice.
Remove some ice cubes; make sure the
ice-full probe is free of ice.
The body of the ice
maker is electrified
The ground line isn't in the
socket.
Use a socket meeting the grounding
requirements.
Scaling occurs
frequently inside
the machine.
The hardness level of the
water is too high.
Install a water-softening device in front of
the water inlet.
Water leaks from
the ice storage bin
The drainhole below the ice
storage bin is blocked.
Remove the ice storage bin and clean the
drainhole.
The drain hose is kinked or
improperly placed higher
than the floor of the ice
storage bin.
Check the drain hose to be sure water can
be drained out unhindered.
Ice is partially
forming or freezing
to evaporator
Debris in the water line
Remove debris from internal water line.
Check the screen in the float valve
Version 8.25.16