Owner's Manual

- 8 - | Page
damage the stainless steel surface.
■ Wash door gaskets on a regular basis, preferably weekly. Simply remove
door gasket from the frame of the door, soak in warm water and soap for
thirty (30) minutes, dry with soft cloth, and replace.
■ Check door gaskets for proper seal after they are replaced.
■ Periodically remove the shelves and clips from the unit and clean them with
mild soap and warm water. To remove the clips, first remove the shelves
and shelf brackets. Then, simply lift the clip up and out.
WARNI
NG
Disconnect power cord before cleaning any parts of the unit or
will not use the appliance for long periods of time!
TRO
UBLE SHOOTING
Before requesting any service on your unit, please check the following points.
Please note that this guide serves only as a reference for solutions to common
problems.
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
Compressor
not running.
Fuse blown or circuit breaker tripped.
Pow
er cord unplugged.
Thermostat set too high.
Rep
lace fuse or reset circuit
breaker.
Plug in power cord.
Set thermostat to lower
temperature.
Replace Temp Sensor / Display
Condensing
unit runs for
long periods
of time.
Excessive amount of warm product
placed in cabinet.
Prolonged door opening or door ajar.
Door gasket(s) not sealing properly.
Dirty condenser coil.
Allow adequate time for
product to cool down.
Ensure doors are closed when
not in use. Avoid opening doors
for long periods of time.
Ensure gaskets are snapped in
completely. Remove gasket and
wash with soap and water.
Check condition of gasket and
replace if necessary.
Clean the condenser coil.