Renaissance Cooking Systems REFR2 Owner’s Manual RCS Indoor & Outdoor Electric Refrigerator PLEASE READ THE MANUAL THOROUGHLY PRIOR TO EQUIPMENT SET-UP, OPERATION AND MAINTENANCE. This owner’s manual was updated November 2020 www.RCSGasGrills.
INSTALLATION IMPORTANT!!! PLEASE READ BEFORE INSTALLATION ■ If the unit has recently been transported，please let unit stand upright for a minimum of 24 hours before plugging it in. ■ Make sure that the unit drops down to desired temperature before loading the unit with product. ■ Make sure that there is proper ventilation around the unit in the area where it will operate. ■ Make sure all accessories are installed (i.e. shelves, shelf clips) before plugging the unit in.
INSTALLING THE GLASS SHELF ■ Open the door. The glass shelf is packed underneath the Refrigerator Basket. ■ Take the glass shelf out of the refrigerator and packaging. ■ Put the glass shelf onto the Protective Pads. CHANGING THE DOOR’S SWING The direction of the door opens could be changed by placing the Upper and Lower Hinges in different corners. Remove the hardware on the Control Panel and Hinges as shown. Place the hinges and door to your preference. Reinstall the Control Panel and Hardware.
TEMPERATURE CONTROLLER The temperature controller is set with a minimum temperature of 33 degrees farenhieght to a maximum temperature of 43 degrees farenhieght. It is perfectly normal for the fridge to vary in temperature from 33 – 43 degrees. Turning Unit On/Off: On: Press UP for more than 3 seconds. Off: Press UP for more than 3 seconds, OFF will flash every other time. Setting Temperature: 1. Press SET for 3 second, the set value will start flashing after a few seconds. 2.
■ Beverages with high alcohol percentage shall be stored in tightly sealed bottles in vertical position. ■ Food should not touch the rear wall of the refrigerator. ■ Try not to open the door too often, ■ Make sure to remove perishable articles of food out of the appliance before you leave for a long time. SAFETY / WARNING Please pay close attention to the safety notices in this section. Disregarding these notices may lead to serious injury and/or damage to the unit.
CAUTION!!! ■ Do not attempt to remove or repair any component unless instructed by factory. ■ Make sure that the unit is not resting on or against the electrical cord and plug. ■ To minimize personal injury, do not hang on the doors. ■ Do not store any flammable and explosive gas or liquids inside the unit. ■ Do not attempt to alter or tamper with the electrical cord.
damage the stainless steel surface. ■ Wash door gaskets on a regular basis, preferably weekly. Simply remove door gasket from the frame of the door, soak in warm water and soap for thirty (30) minutes, dry with soft cloth, and replace. ■ Check door gaskets for proper seal after they are replaced. ■ Periodically remove the shelves and clips from the unit and clean them with mild soap and warm water. To remove the clips, first remove the shelves and shelf brackets. Then, simply lift the clip up and out.
Cabinet temperature is too warm. Evaporator coil iced over. Unplug unit and allow coil to defrost. Make sure thermostat is not set too cold. Ensure that door gasket(s) are sealing properly. Thermostat set too warm. Set thermostat to lower temperature. Re-arrange product to allow for proper air flow. Make sure there is at least four inches of Clearance from evaporator. Allow adequate time for product to cool down. Replace fuse or reset circuit breaker. Clean the condenser coil.
Parts Diagram Parts List Number Parts Number Description Quantity 1 2 3 4 5 6 7 8 9 10 11 12 13 14 ORFR001 ORFR002 ORFR003 ORFR004 ORFR005 ORFR006 ORFR007 ORFR008 ORFR009 ORFR010 ORFR011 ORFR012 ORFR013 ORFR014 Cabinet Upper Shelf Glass Shelf Basket Shelf Support Clip Glass Shelf Protective Pad Shelf Bracket Slide Set Caster Level Adjuster Door Gasket Door Key Upper Hinge Bottom Hinge 1 2 1 1 8 4 4 1 2 2 1 2 1 1 -3-|P a g e
