User Manual

very likely that the carburetor mixture settings will need
to be adjusted to obtain optimum performance.
NOTE: A. Never make adjustments to the carburetor while it is running. Always use a
tachometer to aid in making adjustments to your carburetor.
B. Do not remove the carburetor spring (2) as the spring helps keep the carburetor
butterfly aligned properly. Merely release the ends of the spring so that it no longer holds
the butterfly closed.
1 Choke Lever
2 Throttle Lever
3 Idle Speed Adjustment Screw
4 Low Speed Mixture Adjustment Screw
5 High Speed Mixture Adjustment Screw
6 Ignition Sensor
The average mixture settings are 1&1/4 turns out for the low speed circuit (See No. 4),
and 1&3/4 turns out for the high-speed circuit (See No. 5). Carburetor mixture adjustment
starts with the low speed circuit. The low speed should be set such that the transition from
idle to full throttle is smooth, even if the throttle is snapped to full. This will likely result in a
slightly rich idle mixture but you’re better off with that than a rough transition. If the engine
dies when the throttle is advanced, the mixture is likely too lean. If the engine stumbles
when the throttle is advanced, the mixture is likely too rich. Since the low speed mixture
has some effect on high-speed mixture, always adjust the high speed after adjusting the
low. The high-speed circuit is properly adjusted when the engine can reach maximum rpm
while in the air, which is usually slightly richer than when it is on the ground. A general rule
of thumb is to richen from the maximum on the ground rpm by about 200rpm. If ever the
engine slows or dies while at full throttle, the high-speed mixture is likely too lean and you
should adjust it as soon as possible or damage can result.
NOTE: Be careful not to run the mixture screws in too far as damage to the screw and / or
carburetor body may result. Also, don’t be tempted to run an overly rich mixture. Gas
engine lubrication comes from the oil concentration in the gas, not from a rich fuel / air
mixture. If you want more lubrication, you can vary the oil mix ratio. A too rich mixture will
only result in poor engine performance and a fouled plug and combustion chamber.
Starting the Engine
COLD Step 1: Close the choke, advance the throttle to very slightly above the idle
position, turn on the ignition and briskly flip the prop through compression until the engine