User manual

[1] MIC INPUTS

RCF F 6X provides 2 mono Mic inputs via XLR connectors. The Balanced XLR Microphone preamp input

provides a gain range from 0 dB to -50 dB. All the F 6X’s MIC-LINE inputs are supplied with an 80 Hz

Hi-pass ﬁlter. Enable the 80 Hz Hi-Pass ﬁlter when using voice microphone to reduce low frequency

pop, bump and rumble noise (see section [7] of this manual). +48 V Phantom Power is provided for the

Mic input: 1-2. Enable the Phantom power in the presence of Condenser and Electret Microphones or

in the event of D.I. box usage (see section [9]).

[2] LINE INPUTS

Line inputs TRS jack 1 and 2 provide a gain of +20 dB to -30 dB to line level signals.

[3] STEREO INPUTS

RCA and TRS jacks 3/4 and 5/6 provide stereo inputs for line sources. Note that MONO sources can be

connected to jack inputs 3 and 5.

[4] MAIN OUTPUTS

These XLR male connectors provide +4 dB balanced audio output coming from MAIN MIX. Connect

your main speaker system to XLRs, named L and R. The audio level of MAIN MIX OUT L and R is

controlled by the dedicated MAIN MIX rotary knob (see section [24] of this manual). L and R XLR MAIN

MIX outputs are replicated with L and R TRS jack.

[5] AUX/FX OUTPUT

This TRS jack connector provides +4 dB balanced audio output from the auxiliary send. Connect your

stage monitors or external effects input here.

[6] FOOTSWITCH

This TS jack connector allows the use of MOMENTARY switches or foot pedals to MUTE and UN-MUTE

the audio from the internal FX return. When the FX is muted via footswitch the red LED near the FX

MUTE button lights up (see the section [23] of this manual). In this state, the effect can be unmuted

either by pressing the FX MUTE button or the FOOTSWITCH again.

[7] CHANNEL 1 AND 2 GAIN

MIC input (XLR). This control permits the gain for MIC input to be set with a range from 0 dB to -50 dB.

If the LINE INPUT (TRS jack) are in in use the gain range permitted is from +20 dB to -30 dB.

[8] CHANNEL 3/4 AND 5/6 GAIN

STEREO LINE INPUT (TRS jack). The control allows a gain range from +20 dB to -30 dB.

[9] +48 V SWITCH

Dedicated to the Mic input this switch allows the enabling of the +48 V Phantom Power to the

Mic input 1-2. Enabling the Phantom power is necessary in the presence of Condenser and Electret

Microphones or in case of D.I. box usage.

OFF

FRONT PANEL FUNCTIONS

ENGLISH