User Manual

LOW IMPEDANCE CONNECTION (8 Ω)

Set the selector to position 6 (8 Ω)�

- The total speaker impedance must not be lower than the ampliﬁer output impedance�

- A speaker total impedance equal to the ampliﬁer output one permits to get the maximum deliverable power

(but a higher impedance entails less power)�

- The total speaker power shall be adequate for the ampliﬁer maximum deliverable power�

- Speaker lines shall be as short as possible (for long distances, it may be necessary to use cables with large

cross-section wires)�

- The impedance of a single speaker is 8 Ω� For example, the total impedance of the parallel of two speakers

is 4 Ω (impedance = 8 / speaker number)�

CONNECTION

Remove the metal protective cover of the speaker backcan to access to the removable Euroblock connector socket�

INPUT LINK

OUTIN

3. CONNECTION AND POWER SELECTION

WARNING! Remeber to ﬁx a safety cord (not included)

to a separate solid surface like a beam or a wall and tie it to

the speaker through the safety loops or to the provided eyebolt

(or both, if necessary, for added safety); the eyebolt must be

securely screwed to one of the three anchoring points (1, 2 ,3)�

The cord must be suitable for the speaker dimension and weight

and, in case of dropping, it must be able to ﬁrmly hold the

speaker and avoid any possible injury�

The two INPUT contacts (+ and -) allow the connection of the input cable, the two LINK contacts (+ and -) can be linked to an output cable for

the parallel connection of other speakers�

Applicable wire section: from 0�75 mm² to 2�5 mm²�

1� Connect the line positive wire to the speaker INPUT +�

2� Connect the line negative wire to the speaker INPUT –�

3� If necessary, connect in the same way the output cable (to link other

speakers in parallel) to speaker LINK + and LINK –�

4� Reﬁt the metal protective cover on the speaker backcan�

SAFETY

LOOPS