Owner's manual

6 7
DIE INSTALLATION
SizerDieInstallation.Threadthesizerdieintothebushinginthetopofthedieplate.
SeePhoto6.
Lowerthe handle,which willlower thedie plateto theshellholder.Threadthe die
downuntilittouchestheshellholder.SeePhoto7.
Be sure all of the play is removed from the press linkage system. To do this, raise the
handletoraisethedieplatetothetopofthestroke.Threadthesizerdie1/8to1/4
ofaturnfartherdownsothepresscamsovercenter.Setthedielockringandyou’re
ready to size. Refer to the instructions included in your die set for further adjustments.
Expander Body and Seat Die Installation: The same steps should be taken when
installing an expander body or seat die. The only difference is that you should leave
1/16to1/8”gapbetweenthedieandtheshellholder.SeePhoto8.
Refer to the instructions included in your die set for further adjustments.
IftheSummit
™
ReloadingPressismountedushwiththefrontofthebench,slipthe
largerdiameterholesinthePrimerCatcherovertheheadoftheCapScrewsandslightly
pullthesmallerdiameterholesovertheshankoftheCapScrews.SeePhoto3.
Ifthe Summit ReloadingPress ismounted back fromthefront edgeof the bench,
attachthePrimerCatcherusingthe2U-shapedconnectors.SeePhoto4.
The Summit Reloading Press Shell Holder Adapter accepts removable type shell
holders. To install, insert the shell holder into the Shell Holder Adapter and twist
slightlytotheleft.Toremove,twistslightlytotheright.SeePhoto5.
Photo 3
Photo 4
Photo 5
Photo 6
Photo 7
Photo 8