User Manual

- 8 -
Photo 13
To install wires on the Switch Block, connect the green
wire (A) to the lower outside and the black wire (B) to the
upper inside connection. The middle connector is not
used. See Ph oto 14.
Photo 14
OPERATION
Note: Ref erence the part s chem atics on pages 13-15 for
more information.
Four changeable plugs are provided: US, UK, AUS and
EU. The power transformer is an automatic switching
120-240 VAC design. Select the proper plug adapter and
install onto the power transformer. Plug in the Power
Supply. Remove the packaging foam inside the Bowl
Assembly and ensure nothing else is inside the Bowl.
CAUTION: T he next s tep will c ause th e Bul let W heel
to start spi nning. Make sur e your fingers are clear of t he
Wheel's Agitators and any other moving parts.
Connect Power Supply to the Power Jack on the
underside of the Bowl Assembly (A). Se e Phot o 15.
Photo 15
With bullets in the Bowl and power applied, the Bullet
Wheel will orient the bullets and fill the clear Bullet Drop
Tube. The angle of the Bowl Assembly may need to be
changed. If bullets that are nose-down feed into the
tube, or correctly oriented bullets fall off the sorting
wheel, see Troubleshooting section for more
information.
When the Powder Measur e is cycled by case activation,
the Cam Plate will slide the Push Bar to al low a bullet to
drop into t he Seati ng Die B ullet Guide . The bulle t is held
in the guide until the case comes up to push the bullet
up against the free floating Bullet Seat Plug.
CAUTION A bullet will be fed with each cycling of the
Push Bar. If a powder drop problem is incurred and that
case is removed from the shell plate station, the bullet
that was fed into the Bulle t Feed/ Seat Asse mbly MUST
be removed from the Bullet Guide. If the bullet is not
removed and the next case is introduced, there will be
two bullets in the Bullet Guide and the bullets will jam
and possibly bend or damage the free floating Seat Plug.
The cartridge then moves to the next station to be
crimped, if necessary.
Add more bullets to the Bowl as needed. NOTE: The
sorting plate may not feed the last 10-20 bullets
effectively.