User Manual

- 4 -
UNPACKING
Refer to the list below to identify parts as you unpack your new Bullet Feeder – Rifle. The foam inside the Bowl Assembly
is for shipping purposes. We recommend you keep the foam in place until you have assembled and installed your Bullet
Feeder. Remove the foam before plugging in your Power Supply to the Bowl Assembly.
1. Bowl Assembly
2. Upper Support Tube
3. Lower Support Tube
4. Support Foot
5. Power Supply and Plug Adapters
6. Bullet Seat Die Assembly
7. Continuous Spring Tube
8. Bullet Drop Tube (clear)
RBF – Parts Bag #1
CAM Plate As sy
10-32 x 1½ BHCS
RBF – Parts Bag #2
Case Switc h Ass embly
Upper Tube
BF – Parts Bag #3
¼-28 x 1½ BH CS(2)
¼-28 x 2 BHC S
10-24 x 1½ SHCS(2)
¼” Flat Washer(2)
¼-28 Hex Nut
Bracket Pin