User Manual

- 11 -
TROUBLESHOOTING
If correc tly oriented b ullets fall off of the s orting plate too
early, change to a shallower Bowl angle adjustment.
Move the Bracket Pin from the 45 or 40 degree position
to the 40 or 35 degree position.
45°position-top
40°position-bottom
35°position-middle
If the wires on the Power Jack should become
dislodged, the green wire (A) goes to the lower
connector, the red wire (B) goes to the upper connection
(nearest the Hub #781209). See Photo 22.
Photo 22
MAINTENANCE
Periodically wipe down the inner part of the Bowl and
Bullet Wheel to remove dust and debris.
Also, disas s emble the Bullet Die Body and clean th e free
floating Seat Plug and Bullet Guide to ensure smooth
function.
The drive belt may need adjustment as the belt wears.
Loosen the two BHCS (#181231 in Photo 23) and apply
more tension on the belt. Re-tighten the t wo BHCS.
Photo 23