User guide

APS PRESS-MOUNTED
PRIMING TOOL INSTRUCTIONS
Carefully unpack the press-mounted
tool and look for the following items:
• APS press-mounted tool
• One small bushing
• One large bushing
• Small primer plug
• Large primer plug
• Cam lock pin
• Adjustment rod assembly
• 7/8-14 lock nut
• Hex key wrench 3/32
To install the APS Press-Mounted
Priming Tool, first install 7/8-14 nut
on the tool adapter. See photo #9.
Thread the tool into your reloading
press approximately seven turns. The
ramp on the tool should be pointing to
the left. Then tighten the lock nut.
Install the adjustment rod assembly
into the ram of the press just like a
shell holder. See photo #10. Slowly
lower the press handle to the bot-
tom of its travel. If it stops before
reaching the bottom of its travel,
stop, raise the handle and either
adjust the toolhead up a couple of
turns, and/or the adjustment rod
down. See photo #10.
Now, select the correct size primer
plug for the primer size you will be
using. There is a small primer plug for
6
Photo #9
Photo #10
Photo #8