Manual

Location of Controls
Back Panel
VIDEO AUDIO
CH_ _ "_UZ _ RFOUT
CH3 CH4 Switch
Selects the channel to which you will tune the TV
to see the VCR picture if you connect the VCR
using one of the basic hookups.
ANT. (Antenna) IN Connector
Receives the signal from an antenna or cable
system that is attached to this connector.
RF OUT Connector
Passes signal to TV using the cable supplied.
VIDEO and AUDIO IN Jacks
Receives signals from another component, like a
VCR or camcorder, when it is connected to these
jacks. Use INPUT or channel number 0,0 to
select VID1 in the VCR's display.panel.
VIDEO and AUDIO OUT Jacks
Sends signals from VCR to another component,
like a TV monitor or VCR, when it is connected
to these jacks.
Display Panel
Cassette-in Indicator
VCR indicato_ _ TIMER Indicator
--ILl
I I
REC Indicator Time, Time Counter, Channel Number
Tape Speed Indicator (or Line Indicator), and Status Indicators
Cassette-in Indicator (n)
Lights when a tape is in the VCR. Flashes while
tape is ejecting.
Channel Number, Line Indicator (VID1), Time,
Time Counter, or Status Indicator
The current time, time counter, channel number, or
line indicator (VID1) appears here.
Status indicators show what the VCR is doing.
BYE Turned off
F.FWD Fast forward
HI Turned on
PLAY Playback
PAUS Play pause
REC Record
REC.P Record pause
REW Rewind
SRCH+ Forward search
SRCH- Reverse search
STOP VCR stopped
T.REC Timer recording
REC Indicator
Lights when the VCR is recording.
Tape Speed Indicators (SP, LP, or SLP)
Press SPEED to change.
TIMER Indicator
Lights when a timer recording is set.
VCR Indicator (Applies Only to Basic Hookups)
Press TV,VCR to turn on or off.
VCR indicator on: Picture from VCR.
VCR indicator off: Picture from TV channel.
24