Manual

Connections Setup
Complete Auto Channel Search
The Auto Channel Search allows the TV/VCR to search _r all channels viewable
through your antenna or cable TV system. This is sometimes called "auto
programming."
1. Press MENU on the remote to display the TV/VCRMA1NMt;2VI./.
2. Press 5 to display the SETUP menu.
3. Press 1 to start Auto Channel Search.
Allow the TV/VCR to search for all channels. Pressing any buttons during
the Auto Channel Search will stop the search and only some channels will
be in the TV/VCR's memory. When the search is complete the TV/VCR will
automatically tune to the first channel in the channel memol T list.
Adding or Removing Channels
You might want to add or remove channels if some of them are not active, have
weak signals, or you do not want fl_em in your channel memory. A channel that
has been removed can still be selected by pressing the remote control's number
buttons.
1. Press MENU on the remote to display the TV/VCRMAINMENLI
2. Press 5 to display the SETUP menu.
3. Press 2 to display the ADD/REMO_" C_NNELS screen. Follow the on-
screen directions to add or remove a channel.
4. You can add or remove more channels by entering the channel number or
pressing CHAN up or down.
Setting the Signal Type (optional)
The TV/VCR automatically selects the signal type (cable or antenna) _r you
during lhe Auto Channel Search. If you want to change the signal type, follow
the directions below.
1. Press MENU on the remote to display |he TV/VCRMA1NMENU.
2. Press 5 to display the SETUP menu.
3. Press 5 to choose between the ANTENNA and CABLE.
After changing the signal type, you might need to re-enter the channel
number you are trying to receive. You might also need to run the Auto
Channel Search again.
Chapter I 11