AUDIO/VIDEO RECEIVER User's Guide
Table Of Contents
- Table of Contents
- First Things First
- Operating the Receiver
- Tour of the Receiver
- Programming the Remote
- Programming the Universal Remote
- Programming the Universal Remote to Control a TV
- Programming the Universal Remote to Control a VCR
- Programming the Universal Remote to Control An Audio Component
- Programming the Universal Remote to Control a Cable Box
- Programming the Universal Remote to Control a Laserdisc Player
- Programming the Remote to Control an RCA DSS® Receiver
- Programming the Universal Remote to Control a Satellite
- Programming the AUX Button on the Remote
- Appendix A: Connecting Your Receiver
- Things to Know Before Connecting the Components
- Using the Subwoofer Connections
- Connecting a TV and VCR
- Connecting an RCA DSS® Receiver
- Connecting a Laserdisc Player
- Connecting a Second VCR
- Connecting a Camcorder or Video Camera
- Connecting a Compact Disc Player
- Connecting a Tape Deck or Minidisc Player
- Connecting Antennas
- Connecting Speakers
- Main Speakers
- Rear Speakers
- Center Speaker
- Connecting Speakers to the Receiver
- Connecting The Subwoofer
- Appendix B: Speaker Placement
- Appendix C: Troubleshooting Guide
- Appendix D: Care and Cleaning
- Appendix E: FCC Information
- Appendix F: Limited Warranty
- Appendix G: Equipment Specifications
- Appendix H: Preset Station List Form
- Index
49
Troubleshooting Guide
Before referring to the checklist below, make sure you have
correctly followed the connecting and operating procedures.
If you have any questions that this booklet cannot answer,
please call your nearest RCA dealer.
Receiver/Tuner Operation
STEREO indicator is off.
• Adjust the antenna.
• The signal is too weak. Connect an external antenna.
• The signal is Mono.
Severe hum or noise.
• The signal is too weak. Connect an external antenna.
• Adjust the antenna.
Remote Control Operation
The remote control does not operate the unit.
• Another function is selected on the remote. Press the
correct function button.
• The batteries are exhausted. Replace all batteries.
• The remote is not pointed at the remote control sensor on
the main unit or there is an obstacle between the remote
and the main unit.
• The remote control is too far from the main unit.
Move closer.
General
No audio.
• Make sure the MUTE indicator on the front panel is off.
• Make sure the speakers are turned on.
• Check the connections.
• Check the power cord connection.
No audio from one channel.
• Adjust the balance control.
• Check the speaker wire connection or connecting cable.
Appendix c: Troubleshooting