AUDIO/VIDEO RECEIVER User's Guide

35
Programming the Remote
Programming the Universal Remote to
Control an RCA DSS
®
Receiver
The remote is preprogrammed to control the RCA DSS
®
receiver. A few of the remote buttons used with the RCA DSS
®
receiver are shown below. You may want to experiment with
other buttons on the remote to see if they work with
your receiver.
Receiver Remote (works like) RCA DSS
®
Remote
DISPLAY SELECT/DISPLAY
PREV CH PREV CH
ANTENNA TV/DSS
CLEAR CLEAR
MENU MENU
MOVE ARROWS ARROWS
Programming the Universal Remote to
Control A Satellite receiver
1. Turn on the satellite receiver.
2. Look up the satellite receiver brand and
corresponding code number(s) in the code list on
the right.
3. Press and hold the DSS•CABLE button on
the remote.
4. Enter the three-digit code from the code list.
5. Release the DSS•CABLE button, then press POWER
or CHAN UP or DOWN to see if the receiver
responds to the remote commands. If it doesn’t, try
pressing DSS•CABLE, then POWER again.
6. Repeat steps 3 through 5 using the next code listed
for the brand of your receiver until the receiver
responds to the remote commands.
This remote may not operate all
models of the brands shown.
SATELLITE Receiver Codes
Chaparral ............................. 080, 081
Cheyenne ..................................... 081
Drake....................................082, 083
RCA DSS
®
System ........................ 000
General Instruments . 092, 093, 094
RCA ............................................... 000
Realistic........................................ 084
Sierra I,II,III .................................. 081
STS1 .............................................. 085
STS2 .............................................. 086
STS3 .............................................. 087
STS4 .............................................. 088
Toshiba ......................................... 089
Uniden ......................................... 090
Video Cipher II ............................ 091