AUDIO/VIDEO RECEIVER User's Guide

30
Programming the Universal Remote to
Control An Audio Component
To program the remote for a remote-controllable audio
component, point the remote at the component and press
the correct component button: CD for a CD player, TAPE for a
tape player, etc. Then, press POWER or CHAN UP or DOWN. If
the component doesn’t respond, the remote needs to be
programmed. Use the codes in the code list on the next page
or on the sheet packed with your remote.
Follow these steps to program your universal remote to
control your audio component:
1. Turn on the component to be programmed.
2. Look up the brand and corresponding code number
in the code list on the next page or on the code
sheet packed with your remote.
3. Press and hold the component button on
the remote.
4. Enter the three-digit code from the code list.
5. Release the component button, then press POWER
to see if the component responds to the remote
commands. If it doesn’t, try pressing the
component button, then POWER again.
6. Repeat steps 3 through 5 using the next code listed
for the brand of your component until the
component responds to the remote commands.
Programming the Remote
This remote may not operate all
models of the brands shown.