Full Product Manual

13
EN
USING THE DVD/CD PLAYER
Note: Most DVDs and your player have region codes that help control illegal distribution of
DVDs. The region code of your player is 1. You can only play DVDs with a region code of 1 or
ALL. The region code for a DVD is printed on the DVD or the DVD packaging.
1. Press DVD button on the remote control to select DVD mode.
2. Gently open the disc door by pulling up the edge of the door.
3. Hold the disc by its edge and gently push it onto the spindle, with the label side facing up,
until you hear a “click”.
4. Push the disc door gently to close it. It takes a short while for your unit to load the disc. After
loading, for most DVDs, the unit will automatically take you to the main menu of the DVD
or start playing the DVD.
5. If the unit does not automatically start playing the DVD, press the PLAY button on the
remote control or
button on your player.
TIP: Press the STOP button once before turning off the unit. This will allow you to resume
DVD playback at the same place the next time the unit is turned on.
Specications and external appearance are subject to change without notice.
TROUBLESHOOTING
The unit does not switch on.
Make sure it is plugged in.
• Press button on the unit or SOUNDBAR
button on the remote control to turn on
the Soundbar.
I have no sound.
Press the VOLUME / button on
the top of the Soundbar or VOL /
button on the remote.
Ensure the source you’ve selected is
outputting audio. If you’re using “audio
out” from your TV, ensure your TV is
congured to output audio (see TV’s
menu settings).
Ensure your AV connections are properly
made (ensure you don’t have any loose
connections).
Ensure you’ve selected the correct source
(input) - the LEDs located on the top of
the Soundbar will indicate the currently-
selected source (input).
Mute is activated (the 4 LEDs on top of the
Soundbar ashes). Press the mute button
on the remote control.
Cannot setup Bluetooth pairing
Reset the bluetooth connection by turning
off and on your connected device, or this
Soundbar, or select other SOURCE on
this Soundbar then back to Bluetooth
mode again.
The remote control doesn’t work
If battery is weak, replace the batteries
and ensure the new batteries are installed
correctly.
Please ensure there is nothing blocking
the remote sensor on the front of the
Soundbar.