Manual

CENTER
SPEAKER
SUB WOOFER
Use _nls jack on the left
back panel to connect
anotner powerea
subwoofer other than
the one supplied.
FRONTSPEAKERS
REAR SPEAKERS(SURROUNDSOUND)
Antenna and Speaker
Wire Connection
Push Speaker terminal tab
down to insert wire.
Release tabto lock wire in
the terminal.
NOTE: Make sure the insulation
is completely removed from the
ends of the Antenna and
speaker wires at all connection
points .
To ease speaker connections, the speaker cords and
the terminals are color-coded.
• Red/Black (Front Speakers),
• Blue/Black (Center Speaker)
• Grey/Black (Rear Speakers).
• Brown/Black (Subwoofer)
Connect the L, R speaker (with red/black terminal) on
the back of the speakers to the corresponding color
on the receiver. Do the same for center (with
blue/black terminal), rear speaker (with grey/black
terminal) and the subwoofer (with brown/black ter-
minal).
Speaker Polarity
When connecting the speakers, make sure the polari-
ties ("+" speaker wire to "+" on the receiver) of
speaker wires and terminals are matched. If the cords
are reversed, the sound will be distorted and will lack
bass ("out of phase" effect).
Connecting the Subwoofer
For RT2280/RT2250, connect the subwoofer with the
speaker cord (brown/black) provided. For RT2250R,
or if you want to connect your own powered sub-
woofer, a mono aural audio cord (not supplied) is
needed (RCA terminal).
This receiver offers a high flexibility for user to use a
large variety of speakers and subwoofers. For more
information please refer to section "Fine Setting of
the Speakers" in "Advanced Sound Control" on page
21.