Installation Guide

23
24
Washing a load of laundry Washing a load of laundry
Control lock
This washer is designed for high efficiency (HE) powder detergent
only. Draw the compartment out and add the recommended
amount of detergent directly into the detergent compartment
before starting your washer. The normal amount of detergent
to use is 1/4 to 1/2 of the maximum amount recommended by
the detergent manufacturer. Always reduce the amo unt o f
detergent if the load is small or lightly soiled, or if your water
is very s o ft. Neve r u s e m ore t h a n t h e m a x i m u m a m o u n t
recommended by the detergent manufacturer.
Step 3: Add detergent
Never pour any liquid bleach directly onto the load. It can cause fabric
damage, such as weakening of cloth fibers or color loss.
Second, select the water level based on a , Medium or
load size. Press the Load Size button to change the water level
setting.
Large Small
First, select your desired washing program.
Step 4: Select your desired cycle and options
Third, select your desired wash cycle steps. If you want the
wash cycle to perform all four steps, just keep them lighted.
Pressing the button will change the number of steps performed.
In addition to Wash /Rinse /Spin
you can select
Soak/ .
Wash , or Spin .
Wash /Rinse /Spin,
Wash /Rinse , Rinse /Spin ,
Press and hold the “ .” and “ ” buttons
simultaneously to activate this function.
The .
Press and hold the “ ” and “ ” buttons
simultaneously again to deactivate this
When Control Lock is activated, no buttons will function
except for POWER and the ability to deactivate Control
Lock as described above.
Temp Program
Control lock will light
function.
The Control lock light will off .
Temp Program
This function is useful to prevent children from changing the operation
status of the unit.
WARNING
WARNING
Small
Medium
Large
Normal
Heavy
Delicate
Quick
Bulky
Spin Only
The Spin Only cycle can help remove some moisture from
clothing to reduce drying time and cost.
Fourth, select your desired water temperature for washing action.
For some cycles, options in this function will be limited accordingly.
Cold light only indicates Cold Water selection
Hot light only indicates Hot Water selection
Note: The temperature setting is just for washing action.
Rinsing action is cold water only for all cycles.
Warm light only indicates Warm Water selection
Soak
Last, you may delay the start time for washing if desired.
Press the Delay button. The display will change from
minutes to hours. Each further press of the Delay button
will add 1 hour to the display up to hours.
One more press will cancel the Delay
function and the display light will turn off.
24
Step 5: Start the cycle
Press the START/PAUSE button to start the washing cycle.
When the washer is running, you should pause the program and wait for the
basket stopped completely before you open the door.
Note:
If you want to cancel the Delay Start function after it is started, you should power
off the unit and reset all functions before restart the unit.
When the washing cycle begins, the Estimated Time in
minutes for the cycle to complete will show and count
down in the digital display. Or, if Delay Start is set, the
display will count down the hours until the cycle begins,
and then change to a minute countdown for the cycle.
Delay(Hr.)
Remain(min)
WARNING
Press the EXTRA RINSE button to add one rinse.
Operating Instructions Operating Instructions
Normal (light)
Heavy (light)
Delicate (light)
Quick (Flash)
Bulky (Flash)
Spin Only (Flash)