Installation guide

Installation/Dish Assembly95
Modular Plug Installation
Different modular crimping tools have slightly different procedures. Follow
the procedure the accompanies the crimping tool you are using.
1. With the cable cut to length, trim the ends so they are straight and not
diagonal.
2. Strip approximately 3/8" from the outer conductor of the cable (this is for
fiat four-conductor telephone line and may vary slightly for twist and
outdoor cable). Do not strip the insulation from the four inner wires of this
cable (see figure 79)
MODULAR
CABLE
Figure 79, Modular Plug Installation Steps I and 2
3. Place the modular plug onto the prepared end of the cable. While doing this,
make sure the cable is oriented correctly in the modular connector. If the
connector is to be plugged into the receiver, follow the color code shown
in figure 80.
Spring Clip
MODULAR
CABLE
Figure 80, Modular Plug Installation Step 3