Installation guide

94 lnstallation / Dish Assembly
Use the following procedure to install a telephone jack:
SAFETY NOTE:
Never work with active telephone lines. When the
telephone is ringing, the current carried on these lines
may shock you. While working on the telephone line,
disconnect the wiring at the point of demarcation. If
you are unable to do this, take all the telephone
handsets off the hook.
I. Find an accessible telephone junction box (this could even be the point of
demarcation). Plan the installation of the cable from that point to the receiver.
2. Remove the customer access cover on the junction box and connect the wires of the
telephone cable to the terminals. Remember to follow the color code: red wires
connect to red wires and green to green.
3. Route the cable to the receiver. Use crawl, attic, and garage spaces where ever
possible. As you route this cable, secure it to wails and other supporting structures
to prevent physical damage.
4. Install the modular plug or RJ11/14 type wall plate.
@
TELEPHONE
CABLE
WIRE
TERMINALS
Figure 78, Telephone Junction Box Terminals