Installation guide

80 InstallationZ Dish Assembly
3. insert a pan head bolt into one of the holes. Thread a nut onto this bolt.
4. Align the remaining three holes and nuts and bolts in each.
5. With a 7/16" wrench, tighten all four bolts. When tightening, use your thumb to hold
the heads of the pan head bolts flat on the dish.
6. Mount the dish on the mast assembly. To do this, slide the mast clamp of the LNB
support ann over the mast. At this point do not tighten the azimuth bolts.
LNB
SUPPORT
ARM
CLAMP
MAST
Figure 65, Mount Dish On Mast Assembly