Installation guide

Installation/Mounting the Dish 71
GROUNDING
CONDUCTOR
GROUND
ROD
°
o
CLAMP
Figure 55, Grounding Pole
least two different locations on the side of the pole. These two measurement
should be at right angles to each other.
Note: The dirt or stone placed in the hole in step two should hold the pole upright.
If not, attach guy wires to the pole to keep it upright.
5. With prepared quick drying cement, fill the hole. Stop filling when the cement level
is about two inches from the top of the hole.
o
Connect the pole to the grounding electrode.
Using a ground damp, connect the grounding conductor to the pole. Then route
the ground conductor to the grounding electrode. Connect the ground conductor
to the ground electrode. A detailed list of grounding electrodes and how to connect
to them is given in appendix C.
6. Let the cement completely dry before proceeding with mounting the dish to the
pole.