Installation guide

58 Installation/Mounting the Dish
Installing the Mounting Foot on a Cinder Block Wall Using Togglers:
DANGER! J
When following these instructions, take extreme care to avoid
contact with overhead power lines, lights, and power circuits.
Contact with power lines, lights, and circuits may prove fatal.
1. Select amounting location. Remember to position the foot so the outside holes align
with the hollow cores of the cinder block.
2. Hold the mounting foot in position and, using a pencil, mark one of the outside
holes.
3. Remove the mounting foot. Then drill a 1/2" hole at the location just marked.
4. Install a toggler wall anchor.
Toggler Installation Steps:
4.1. Insert the metal channel end of the toggler into the hole. To do this, hold
the metal channel alongside the plastic straps and slide it through the hole.
METAL
FOLD
IN
WALL
Figure 42, Toggler Installation Step 1
4.2. With one hand, pull the ring so the metal channel rests flush behind wall.
With the other hand, slide the plastic cap along the straps unit the flange of
the cap is flush with the wall.