Installation guide

Installation/Mounting the Dish 51
13. Check the tightness of all bolts and proceed to the Assembling the Dish section.
Installing a Spacer (Optional)
If the siding is too narrow for the mounting foot, aspacer must be installed. The spacer
can be held in place by the lower two mounting bolts of the mounting foot. To do this,
use the following steps.
1. Remove the lag bolts from the lower outside holes of the mounting foot.
2. Insert the spacer under the mounting foot and mark the location of the two outside
holes. If the space has not been previously sized, mark the size of the spacer using
the mounting foot as a guide. Use these marks to trim the spacer to the correct size.
3. With a 1/4" drill bit, drill the two holes just marked.
4. Slide the spacer under the mounting foot and reinstall the two lag screws in the
outside holes.
5. Once the spacer is installed, check tightness of all bolts and proceed to Assembling
the Dish Components section.