Installation guide

Installation 41
.
,
Move the bubble level (or plumb line) 90 degrees and measure. If level, double
check both measurements and secure the foot (skip steps 5 and 6). If it is not
level, continue to step 5.
If the side to side measurement of the mast is not level, use spacers to level
it. To use spacers, determine the side that must be raised. Then, place 5/16
washers under the foot to level the mast. Position these washers under the
mounting holes so the mounting bolts will secure them.
6, Once the side to side measurement is level, confirm the level of both
measurements and secure the foot to the surface. Always double check the
level of the mast after it is secured. If it is not level, re-adjustment may be
necessary.
Instructions for leveling is also given in each horizontal system installation proce-
dure.