Installation guide

112 Installation/AligningtheDish

FIRST

MARK

SECOND

MARK

CENTER

MARK

Figure 96,Azimuth Adjustment with Audio Tone

Aligning with the Audio Tone

1. To listen to the audio tone, use a television, stereo, or wireless headphones.

Connect the satellite receiver's audio output connector to the device you are using.

Gendy turn the dish either right or left one tick mark of the alignment tape and

pause. If the receiver outputs a continuous tone, mark that position on the mast.

If the receiver continues to output tone bursts, wait for one complete tuning cycle

(listen for the audio tone to beep twice) and move the dish (in the same direction)

3 degrees. Continue this sequence until a continuous tone is heard, mark that

position on the mast.

Note: If you move the dish about 30a in one direction, move back to the starting

point and continue the same sequence moving the dish in the opposite direction.

3. Once acontinuoustone is heard andthe mast marked,continuerotatingthe dish

three degrees(in the samedirection)untilthe continuoustone stops. Markthat

positionon the mast.