Manual

.V"':'.'/.
• RmOTE_
BACK PANEL CONTROLS•
IN FROM ANT Useto connect an off-air antenna or cable TM signal
to the DSS®system.
OUT TO TV Useto connect the DSS®receiver to your TV. However, if
your TV has audio/video jacks, you should use those jacks to get
better picture and sound quality.
CH3/CH4 SWITCH If a coaxial cable is used to connect the DSS®
receiver to your TV, you must set the CH3/CH4 SWITCH. For example,
to see the DSS®signal on TV channel 3, set the switch to 3.
S-VIDEO Provides the best picture quality. If your TV has S-VIDEO
capability, use this jack along with the audio/video jacks to connect •
the DSS®receiver to your TV.
VIDEO Provides better picture quality than the OUT TO TV jack. If
your TV has audio/video capability, use this jack to connect the DSS®
receiver to your TV. You must also connect the AUDIO jacks.
AUDIO (R and L) Provide'better sound quality than the OUT TO TV
jack. If your TV has audio/video capability, use these jacks to connect
the DSS®receiver to your TV. You must also connect the VIDEO jack.
AUX RF ANT IN Use to connect an optional RF antenna for RF •
remote signals. Connecting an antenna extends the remote's range.
WIDE BAND DATA PORT This port allows you to connect the DSS®
system to future services anc/accessories. A shielded cable and
additional hardware may be required.
LOW SPEED DATA PORT this port allows you to connect the DSS®
system to accessories,such as the Home Control base module.
SATELLITE IN Use to connect the DSS®receiver to the satellite dish.
PHONE JACK Use to connect a phone line to the'DSS ®receiver. The
DSS® system requires a phone line connection to periodically call out
to program providers.
VCR CONTROL Allows the receiver to control your VCR.
REMOTE IN Use !n conjunction with a remote control signal sender.
59