Manual

JACKS AND CABLES

S-Video Jack and Cable

The S-Video jack provides the best picture quality for your DSS®

system.

This jack is available on many TVs and is used in conjunction with

audio cables to connect the DSS® receiver to your TV. Remember

also to connect the left and right audio cables because the

S-video jack carries only the picture signal, not the sound.

S-VideoJack

Audio/Video Jacks and Cables (RCA-type)

The audio/video jacks provide very good picture and stereo

sound quality, and should be used if your TV has no S-Video jack.

Theses jacks are used for most audio/video connections between

components. The DSSe receiver audio/video jacks are color coded

(yellow for video, red for right audio, and white for left audio). If

your TV has only one input for audio (mono), connect it to the

right (red) audio jack on the DSSe receiver.

Audio/VideoJacks

RF Jacks and Coaxial Cables (F-type)

The RFjacks provide good picture and mono sound quality, and

are to be used if audio/video connections are not available for

your TV.

These jacks are required for antenna or cable-TV connections.

The RFjacks on the DSS®receiver are labeled IN FROM ANT and

OUT TO TV. The coaxial cable supplied with your DSS® system is

used to connect the RFjacks between the DSS® receiver and your

TV°santenna input.

VCR Controller Jack and Cable

The VCR controller cable plugs into a jack on the DSS®receiver's

back panel. The other end of the cable affixes toyour VCR's

remote sensor.

RFJack

VCR Controller Jack