Manual

Dubbing to Another Digital Video Camcorder Equipped With an
IEEE 1394 Connection Port
Connector Cover
DV IN/OUT
Connection Jack
(Open when connecting cables)/
IEEE 1394 F_
Connection Cable
Video unit equipped
with IEEE 1394 connector
To DV IN/OUT
ConnectionJack
Digital Dubbing Using IEEE 1394
Jacks
When sending a digital signal from
one DV device to another, there is
little if any image or sound
deterioration.
"l_ Use This Camcorder as a Player:
1. Make sure the power of both
camcorders is off.
2. Connect one end of the 1EEE 1394
cable to each digital camcorder.
3. Press the camcorder's Play/Pause
Button (Wll) to start playback.
4. While watching the playback on
the monitor, start the receiving
camcorder's record mode from the
spot on the source tape you want
to begin recording.
Notes:
It is recommended to use the AC adapter/
charger as the power supply instead of the
battery pack for uniform playback.
For digital dubbing, this camcorder can
be connecled to only one device at a time.
This camcorder can also be used as the
recording camcorder.
If a blank portion or distorted image is
played back during dubbing, the process
may stop to avoid capturing problem
images.
Even though the IEEE 1394 cable is
connecled correctly, sometimes the image
may not appear during playback, tf this
occurs, turn off the Ix_wer and make
connections again.
When using an IEEE 1394 cable, be sure
it has a core filter attached. The core filler
reduces interference and is required to
meet FCC standards.
55