Manual

Troubleshooting
Most problems you encounter wilh your TV/VCR/DVD can be corrected by consulting the Troubleshooting list that lk)llows.
General TV/VCR/DVD Problems
TV/VCR/DVD won't turn on
Make sure you tW the following buttons on the remote: TV, VCR DVD, and ON-OPE
Something might be wrong with your remote control. Press the POWER button on the front of the TV/VCR/DVD. if the TV/VCR/DVD
turns on, check the remote control solutions on page 67.
Make sure the TV/VCR/DVD is plugged in.
Check the wall receptacle (or extension cord) to make sure it is "live" by plugging in something else.
Controls don't work
if you're using the remote" control for TV f_mctions (such as changing channels), press the TV button first to make sure the remote" is
in TV mode.
Unplug the TV/VCR/DVI) fbr 2 minutes and then plug it back in. Turn the TV on and tW again.
PROGRAM EVENT indicator lit on the fi-ont panel of the TV/VCR/DVD. Timer recording set. Press TIMER on the remote to turn off
the indicator. Remember to press TIMER to reset the timer recording when you are finished.
TV/VCR/DVD turns off unexpectedly
Sleep timer may have been activated. Go to page 56 for instructions.
TV/VCR/DVD turned on with On Timer. Automatically turns off after two hours if no other control is used.
Electronic protection circuit may have been activated because of a power surge. _lait 30 seconds and then turn the TV/VCR/DVI) on
again, if" this happens frequently, the voltage in yore house may be abnormally high or low.
TV/VCR/DVD turns on unexpectedly
On timer (alarm) may have been activated. Go to page 56 f_:)rinsti_actions.
Blank screen
TW another channel.
Check vide() adjustments. Go to page 57 for infb about the l/_li)gO ADJHS7menu.
Make sure the line input isn't selected. Repeatedly press INPUT on the remote to switch between audio/video input jacks and the
tuner.
Make sure blank portion of tape is not playing.
No sound, picture okay
Press the VOL up button to increase the sound.
Maybe sound is muted. Press the MUTE button to restore sound.
Digital Audio Output is available dming DVI) playback only.
Check audio settings f_:)rTV/VCR and DVD.
Check audio connections. Make sure the audio cables are firmly connected to the jacks.
No picture, no sound but TV is on
Press '['V on relqOOtc' to put remote in TV mode.
The channe] might be empty -- change channe]s.
66